Deutsch English Español Russian polski 🗛 🗚

Modulos ◄Kits ◄Cajas ◄Assortments ◄Devices ◄Other ◄Impressum
Deutsch English Español Russian polski 🌗 🗛 🗚

M172 Setup

montage

How is the device connected to the dynamo?

Please find out which of the two cables coming from the dynamo is connected to the centre lamp contact. Once the correct cable has been determined, it has to be separated within close proximity to the M172. Take the end coming from the dynamo and connect it to the “Dynamo” connection on the M172. The other cable end (going to the two lamps) is connected to the “Light” connection on the M172. The “Frame” connection is connected with the wire that runs from the outer lamp contact to the dynamo. Note: When using a wheel hub dynamo, it is possible that at speeds of > 40 km/h the charge controller switches off the due to a too high dynamo voltage. However, at lower speeds it will automatically switch back on.

Copyright © 2024 Kemo Electronic GmbH